Looking to sell or trade a nice working Tecumseh Ah520 model, 1585b type horizontal shaft, 2 cycle engine off a Toro S200 push snowblower.
It's the model with both high & low speed carburetor fuel mixture adjustment needles/screws.
Starts & runs fine.
Carb recently cleaned. New carb diaphragm & spit cup gasket.
Also cleaned the block and blower housing & tightened the pull cord spring on the latter (sorry, accidentally deleted those photos, but it will be obvious that I did so when you see the engine up close in person).
Includes ignition switch, primer line, exhaust elbow, shaft key, and mounting nuts & washers.
Shaft is approx 3" long & 5/8" in diameter.
Engine currently mounted on another old S-200 frame so I can demonstrate it working easier. Will be removed from frame after sale. Bare engine only - fuel tank & shaft pulley not included.
Good replacement engine for Toro S-200, S-620, SnowMaster 20, or CR20 model push snowthrowers or for one of those really old, 2 man ice (fishing) augers.
Installation not included. If you want the engine installed on your push model Toro, it's $40 extra, you have to send me photos of your snowthrower for confirmation, then bring it over, and I get to keep your old engine for parts.
Asking a firm $60 - less than half what it would cost for a carburetor cleaning & rebuild at a shop.
Will also swap it for a good condition 1" diameter shaft leafblower or polesaw attachment for Ryobi, Craftsman, Echo, Troy Bilt, etc "Expand It" type 2 stroke trimmer powerheads.
Pick up only.
Swap/sale is final.
If ad is here, it is available.
do NOT contact me with unsolicited services or offers